FACEBOOK  EBAY TWITTER GOOGLE U-TUBE

GSW ON FACE BOOK

Picasa

GSW ON FACE BOOK

UTUBE.png (35397 bytes)

THEY BUY GOLD

ROCK F/B

255 ALBUMS

GSW F/B

YOU-TUBE

THEY BUY GOLD

twitter.jpg (1475 bytes)

EASY SOCIAL SHOP

OUR WATCH-MOBILE

NAWCCb.gif (2636 bytes)

TWITTER

SOCIAL SHOP

PHOTO-BUCKET

WATCH-MOBILE

NAWCC

 
restored serviced warranted appraised watches in america >-->
100 restored vintage watches >--->
go to gsw mwb vintage watches

 

Corporate Hosting Org

SEIKO 62 MAS DIVE 6217-8001
Production date: Jun, 1967
125.00 RESTORE SERVICE AND WARRANTY

TOP

 SEIKO DIVE 6217-8001
case-case back-bezel-dial-hands-movement original
Production date: June, 1967

COST TO PERFORM WORK INCLUDING PARTS 125.00
(NOTE, AS A REPEAT PATRON, GSW COVERED THE COST OF MAIN SPRING & CASE SEAL )

IMG_4917.JPG (127913 bytes)

serviced the movement. new main spring. cleaned dial, replaced crystal .with client supplied new crystal.
relumed original hands due to the fact that client supplied minute replacement hand did not fit. 

TOP

IMG_4904.JPG (128117 bytes)

replaced the unsigned non-original crown with client supplied seiko crown that is slightly larger than the original.. 

IMG_4919.JPG (128804 bytes)

First model (62MAS) divers with dolphin-logo

TOP

IMG_4916.JPG (132187 bytes)

cut down client supplied seiko dive bracelet from 20 to 19MM. had to remove an additional 1mm from the
top link on either side AND from front or top of top link to keep it from hitting lugs.

TOP

IMG_4918.JPG (118026 bytes)

case and bracelet were brush finished

TOP

IMG_4901.JPG (127800 bytes)

 

original bezel on left is the first model diverīs bezel is bi-directional with no "clicks" with
a lume dot with 4 minute dots on either side of the lume

bezel on right was supposed to be the replacement, but you can see that it is thinner in height then the
original and it has a triangle instead of a dot

TOP

IMG_4902.JPG (114648 bytes)

the bezel problem was compounded by the fact that the wire spring keeper on the left, the original, is thicker
(X 1.5) than that of the right replacement ring.

TOP

IMG_4903.JPG (137665 bytes)

when we attached the replacement to the watch, the bezel is too loose due to the fact the channel in the case
above is wider than that of the replacement, so it was not tight,

We attempted to use the thicker original ring in the replacement bezel,  but the channel IN the BEZEL was
too narrow.
********************************************************